Microtopping is a thin cementitious overlay applied over existing concrete to create a smooth, decorative new wear surface without a full slab tear-out.

Joint filler is a semi-rigid epoxy or polyurea material used to fill saw cuts and control joints in a slab before a coating goes down, for a smooth, continuous surface.

Epoxy crack injection forces low-viscosity epoxy resin into a concrete crack under pressure to bond it back together and restore strength.

Freeze-thaw resistance is a concrete or coating’s ability to withstand repeated cycles of freezing and thawing without cracking, scaling, or losing adhesion.

A curing compound is a liquid membrane sprayed onto fresh concrete to slow moisture loss so the slab gains strength properly. It is not the same as a sealer and can block coating adhesion if left on the surface.

A concrete overlay is a thin cement-based layer applied over existing concrete to resurface, repair, or decoratively refinish a worn slab.

A waterproof membrane is a continuous layer of material, liquid applied or sheet applied, installed to block water from passing through concrete, decks, or below grade structures. It works as a barrier system rather than relying on the concrete itself to keep water out. Types of Waterproof Membranes Liquid applied membranes are rolled or sprayed […]

Efflorescence is the white, powdery, or crystalline deposit that forms on concrete or masonry surfaces when water moves through the material and evaporates, leaving mineral salts behind. It is one of the most common surface issues installers run into on slabs with moisture problems. What Causes Efflorescence Efflorescence happens when water dissolves soluble salts inside […]

A control joint is a groove cut or formed into a concrete slab to create a planned weak point where the slab will crack as it shrinks during curing. Rather than cracking randomly, the concrete cracks cleanly along the joint, keeping the surface looking intact. Why Control Joints Matter Before Coating Concrete naturally shrinks as […]

A concrete densifier is a chemical treatment that hardens and strengthens the surface of concrete, commonly used in polished concrete floors.